Problems using My Ooma? Ideas on how we can make it better? You’ve come to the right place.
#53052 by weysonn
Wed Apr 14, 2010 11:05 pm
My Telo randomly got stuck on the solid blue 1 2 lights and is no longer working.
Is there any way to reset it?
If I unplug it the Telo still boots up with solid blue 1 2 lights.
I also can't access the page when connecting with my computer.
#53228 by ntoy
Sat Apr 17, 2010 7:56 am

Last log shows that it was in the middle of a software upgrade on 4/14.

You can try a factory reset:

-Power off the Telo unit, wait about a minute, then power it back on.
-When the logo starts flashing RED, press and hold 'Stop' and 'Trash' keys at the same time.
-The logo should then flash blue & red.
-Release the stop & trash buttons when the logo turns solid blue
-Then allow for some time & try not to disturb power.
-It should go through another reboot

Who is online

Users browsing this forum: No registered users and 5 guests