In one room I have the DSL line from the wall --> modem/router --> ethernet port
All the ethernet ports in my house meet at a hub.
In another room of my house, I have ethernet wall port ---> ooma hub ----> computer, where the computer (with Windows Vista) is connected to the home port of the hub. In another room, I have an XP computer connected wirelessly as my router supports wireless.
My home network has an IP prefix of 192.168.1
But by connecting my Vista computer to the ooma hub, all of a sudden it's IP address has changed to a 172.27.35 prefix, and as a result, I can no longer establish a home network connection or transfer files between my computers.
I have a hunch that maybe I can go into www.setup.ooma.com and change some settings to let my Vista use the IP address it used to have before ooma got stuck between it and the wall. Can anybody confirm if there's a way to do this, and if so, possibly give me instructions on how to do it?
Get an inexpensive switch and connect the switch to the LAN port in your wall.
Connect ooma and the computer to the switch.
Leave the Home port of ooma unused.
Your network will be back in business.
Telo with 2 Handsets, a Linx, and a Safety Phone
Telo2 with 2 Handsets and a Linx
You can either get a small switch to split that one ethernet jack in the wall for both the computer and the Ooma, or (and I assume this can not be done) run a new network cable to the room all together). Lastly see about moving the Ooma box in the same location of your network hub (most likely it is actually a switch).Zindar wrote:Okay; I had thought of that solution, but somebody thought I might be able to use setup.ooma.com to do as I described above (but they weren't sure), so I thought I'd check here to confirm. Thanks for the advice.
Therefore, it sounds like I do really need a port switch device.