Problems using My Ooma? Ideas on how we can make it better? You’ve come to the right place.
#106720 by azism
Sat Feb 16, 2013 10:17 am
Under the Telo setup screen ( is an advanced section. In it is one question or option saying "Allow access to web interface from INTERNET port ". Of what use is this option? Or should I say what is it there for? It must have some use, but I'm not going to activate it. Too bad Ooma doesn't provide better documentation with the Telo so a user understands all these options and why or what they are used for.

#106721 by murphy
Sat Feb 16, 2013 10:51 am
When the Telo is located behind your router and the Home port is not used it allows access to the setup pages by going to the IP address that the router assigned to the Telo.

If the Telo is in front of the router it should never be checked.
#106727 by azism
Sat Feb 16, 2013 12:35 pm
#106891 by azism
Wed Feb 20, 2013 8:37 am
A followup here regard the Telo and the wireless adapter. In order for the phone system to work, do I still need the telephone's base unit plugged into the Linx?
#106905 by azism
Wed Feb 20, 2013 11:48 am
So far I have not been able to get the phone system to work with the wireless adapter (dongle). All I get with this adapter is a busy signal and the Ooma logo blinking red. The is with or without the Linx. I don't have a hardwired phone system in my house so my phone system is completely wireless. So my guess is at the moment that the wireless adapter (dongle) will only work with the Ooma phones themselves, not my AT&T Dect 6 phones?
#106907 by azism
Wed Feb 20, 2013 12:43 pm
1.Plug the Adapter into the USB port on the back of your Telo DID THAT!
2.Using an Ethernet cable, connect the HOME NETWORK port on the back of your Telo to a computer DID THAT!
3.Use the computer and open up a browser to DID THAT!
4.Click on the Wireless tab on the left side of your screen and follow the directions to connect the Telo to your wireless network DID THAT!

Once your Telo has connected to your home Wi-Fi network, you’ve gone wireless! If you need additional assistance, you can find help in the Quick Start Guide that came with your device. DID THAT!

The instructions seem simple enough, but I'm getting nowhere. That Quick Start Guide sure leaves a lot to be desired. At this point in time I am thinking I'd be better off returning the Wireless Adapter and staying with the Linx.
#106909 by lbmofo
Wed Feb 20, 2013 12:49 pm
Once you specify which wifi network to connect to and you provide the password to the network, Telo should remember which network to connect to and all you have to do at that point is to disconnect the ethernet cable from Telo and then Telo should connect wirelessly to your router.
#106912 by WayneDsr
Wed Feb 20, 2013 1:01 pm
I'm not understanding the connection between the wireless and the Linx.... they are two different things and operate independently. Maybe I'm the one that's confused......


Who is online

Users browsing this forum: No registered users and 5 guests