Need extra help installing your Ooma Hub or Telo system? Let us know.
#45771 by Morpheus
Sun Feb 07, 2010 9:49 am
I have one of the new ooma devices and two handsets, using latest firmware. My TWC connection is 6MB. I have My ooma connected to the Linksys WRVS4400N router.

I seem to be getting bad call quality during file transfers and it cuts out.

What is the best way to connect this to my internet connection? Is there some settings that I need to set for optimal usage?

Thanks...
#45803 by Morpheus
Sun Feb 07, 2010 11:34 am
Ok, I have QoS on my router and ooma is plugged into port 1

There are a lot of settings for this. Is there a guide somewhere that will explaine how to set this up?

ooma: Port 1 on Router

Voip Speed Test:
Image

I have three settings inder QoS

Bandwidth Management | QoS Setup | DSCP Setup

Bandwidth Management Tab:
Image

When Enabled there are three options activated:

1)The Maximum Bandwidth provided by ISP
2) Type: Rate Control
3) Type: Priority

Rate Control Selected:
Image

In the above Direction drop down there are:
Upstream
Downstream

In the above Service drop down there are:
Image


Priority Selected:
Image

In the above Direction drop down there are:
Upstream
Downstream

In the above Priority drop down there are:
Low
Normal
Medium
High

In the above Service drop down there are:
Image

QoS Setup Tab:
Image

DSCP Setup Tab:
Image

I'm not real sure about any of these settings?

Will I need to adjust anything in the ooma when these are set?

Any help will be greatly appreciated.

Who is online

Users browsing this forum: No registered users and 8 guests