Need extra help installing your Ooma Hub or Telo system? Let us know.
#109399 by cwradio
Tue Apr 30, 2013 5:55 pm
How do you check your WiFi Telco configuration via a WiFi connection? I know how to do it via a ethernet wire connection.
Thanks Paul
#109411 by cwradio
Wed May 01, 2013 6:46 am
lbmofo wrote:You can enable "Allow access to web interface from WIRELESS port" when you are in http://setup.ooma.com or better yet, do TCP port forwarding of port 80 to 172.27.35.1

Thanks
I set allow from Wireless port to on(no port forwarding). Then typed in the IP address into browser (192.xxx.xx.x).
I found the IP address from checking my modem-router tables.
I
#109413 by cwradio
Wed May 01, 2013 7:41 am
lbmofo wrote:If you find that check box unreliable in the future, do the port forwarding.

Question about PORT Forwarding setup configuration on the Telco:
Set Start port to: 80
Set End Port to: BLANK
Set TYPE to: TCP
Set FORWARD to IP address to: 172.27.35.1
Set FORWARD port to: 80

Reboot Telco
Type 172.27.35.1 into browser to access setup in TELCO.

Did I get it correct??????
Again thanks ibmofo...
#109415 by lbmofo
Wed May 01, 2013 8:41 am
cwradio wrote:Type 172.27.35.1 into browser to access setup in TELCO.

Did I get it correct??????

Even with port forward, you would access the setup page via the IP address assigned by your router.
The port forward just gets you to the setup page (Home Network port) when you reach Ooma's "To Internet" port.

Who is online

Users browsing this forum: No registered users and 10 guests