If you want to get ooma dialtone from all your wall jacks inside your house on top of being able to plug in a Scout in any wall jack, do the following:
Use one of these (on the other side of this adapter, there is just 1 port instead of 2):
Plug the unplugged plug into the single port (take out the inline coupler), plug the Hub's wall port into 1 of the 2 ports and plug the Hub's phone port into the other port.
If you can't find one of the adapters above, just use these kinds but you'll still need the inline coupler connected to the uplugged plug.
A duplex splitter similar to this came with your ooma device; this will also work:
If you want to connect a phone to the Hub as well, just plug one of these into the phone port of the Hub so you can turn Hub's 1 phone port into 2.
By the way, where are those thick brown wires connected to your red & green screw terminals coming from?
1) my ping is showing up too high when i run speedtest.net report (the speed results continue to show optimal speed down and up both but when i actually surf web, i can see the lagging in loading pages and slowness is there....why?
2) i noticed last night when i was walking by the scout, the blue light disapperaed and red light started blinking for roughly 1 or 2 mins and then blue light came back on and its working fine again. why does this happen? should i be worried? does it have anything to do with issue number 1?
Check out a few things: viewtopic.php?f=4&t=8159#p57483
now its red light blinking on scout but the phone works fine.....internet is fine too but gotta be something wrong since its red blinking light and not blue solid
If the Scout's ooma tab turns blue, that means something is wrong with your house wiring.
Does that mean I should not use the splitter that came with ooma to plug both phone and wall jack together in to my house wiring?lbmofo wrote:To distribute ooma dialtone throughout the house, you need to be certain that nothing else is connected to your house wiring that may apply some kind of voltage; otherwise you may damage your Hub.
No. It means that if you don't have DSL then you need to make sure your internal phone wiring is disconnected from the utility at the NIB - the phone box on the outside of your house. You can usually just unplug the little modular cords to accomplish this. Disconnecting them means that you will not be sending your ooma dialtone to their equipment and their equipment will not be interfering with your system. I also recommend a note that says, "Do not reconnect. Customer Equipment may be damaged."roadshow wrote:Does that mean I should not use the splitter that came with ooma to plug both phone and wall jack together in to my house wiring?lbmofo wrote:To distribute ooma dialtone throughout the house, you need to be certain that nothing else is connected to your house wiring that may apply some kind of voltage; otherwise you may damage your Hub.
If you have DSL you need to use a "clean" pair of wires for sending the signal to the rest of the house.
And don't even get me started if you chose to "integrate" your old telco landline with your ooma.
VoIP hardware: 2 Telo w/3 handsets & Linx / ooma core
Total Lines: 8 / Numbers: 11 / Handsets: 20
Lifetime Premier Member
Friends don't remember what Landline Integration was or why we did it.