Select the Network page.
Set the Network Connection to Dynamic (DHCP)
Click the radio button beside Use built in under Modem port MAC address
Turn the modem, ooma, and the router off.
Turn on the modem and wait until it syncs up with your ISP.
Turn on the Telo and wait until all of the lights are blue.
If it has never connected before, this could take up to an hour.
Enjoy the light show but under no circumstances disconnect it's power before the hour is up.
Turn on the router.
Verify that you can connect to the internet with your computer.
Verify that you have a dial tone on a phone connected to the phone port.
Nothing should be connected to the wall port unless you chose to integrate a land line with the Telo.
If you did choose integration, your land line must be connected to the Wall port.
Telo with 2 Handsets, a Linx, and a Safety Phone
Telo2 with 2 Handsets and a Linx