Need extra help installing your Ooma Hub or Telo system? Let us know.
#19320 by dzjepp
Tue Sep 08, 2009 8:35 am

I have an Actiontec GT724WGR acting as my gateway (it's a DSL modem/4 port router/wireless combo) for my dry-loop AT&T DSL (midwest).

I first connected the Actiontec to my computer to get it to connect to the internet. It worked ok. Then I connected the Ooma hub to the Actiontec according to the manual and it works ok too (the scout works too). I have a question or two though:

- Right now I can't login to my Actiontec via browser, without Ooma hooked up I can login ok. I wonder if it's an issue that both my Actiontec and Ooma hub are using different DHCP settings.

- Can I setup Ooma to use the same DHCP settings as my gateway? Do I need both devices to have DHCP settings?

- I want to use the gateway to setup QoS rules for all my devices, can I use it to setup Ooma hub QoS, instead of using to setup Ooma QoS?

Is there a good guide for setting up QoS for internet use?

That's it for now, thank you
#19324 by Groundhound
Tue Sep 08, 2009 10:03 am
Lots of questions, starting with the first one. Is your computer connected directly to your router or is it connected to the Ooma hub's home port? If connected to the hub, switch it to the router (you did say it was 4-port?). That should clear up access to the router login issue. At that point you will find that you will not be able to access, but you can get around that by using the IP your router assigns to the hub to access the hub's setup.
#19331 by dzjepp
Tue Sep 08, 2009 12:13 pm
Ok thanks I did that (Gateway login works) however now I can't login to Ooma setup (default Ooma does not show up in my Gateways connected devices (should it?) Gateway has UPNP/NAT enabled firewall disabled.
#19332 by southsound
Tue Sep 08, 2009 12:26 pm
Just had this situation with my setup. Check your gateway to see what IP address was assigned to your ooma hub and write it down. Then connect a pc to the home port of the hub, go to the advanced configuration page at and put in the DMZ. Reconnect your computer to the gateway and reboot things - starting with the modem/gateway and finally the ooma hub. Your setup page will be available at the IP address you wrote down for the hub.

<<tommies or other experts - check and make sure this is correct. tommies got me working last week and I believe this is what he had me do.>>

Who is online

Users browsing this forum: No registered users and 6 guests