Having trouble placing or receiving calls or using your voicemail system on Ooma Telo VoIP Phones? Post your questions here.
#15671 by amigo108
Wed Aug 12, 2009 1:45 pm
I have the scout and a second number assigned to my account. Incoming calls on either line ring to my phone but outbound calls are all routed on the primary line. I want to be able to make outgoing calls on both lines if I can.

I have 2 pair wiring through my whole house and can feed either the first or second set independently (so I can have a line 1 and a line 2) Until tomorrow, I have the VOIP line that I had through Comcast cable feeding that second pair (orange/orange white) currently on my 2 line phones. I get the ooma tone on line one and the regular dial tone on line 2.

I wanted to replace that line 2 with my second line through ooma after Comcast disconnects their the cable VOIP phone line and swap out my modem tomorrow. But upon experimenting on hooking the scout up to a third line or seperate/Independent telephone, it seems that everything still goes through line 1 (primary ooma line) and that the second line/number that ooma assigned to me can only be used for incoming calls.

Is there a way to have both ooma lines act independently (incomeing and outgoing ringing to different phone lines?

Last edited by amigo108 on Thu Aug 13, 2009 11:45 am, edited 1 time in total.
#15675 by murphy
Wed Aug 12, 2009 1:50 pm
Assign your second number to a scout and it will only ring on the phone connected to the scout. It will not ring when the first number is called.
#15695 by murphy
Wed Aug 12, 2009 3:50 pm
Don't confuse the line 1 and line 2 buttons with the two phone numbers. They are not related. The first call will always use physical line 1. It doesn't matter whether it is being made from the hub or the scout. A second simultaneous call will use physical line 2.
#15813 by amigo108
Thu Aug 13, 2009 11:44 am
Well, after a bunch of head scratching I called Ooma tech support and it appears they had the serial number of the scout entered wrong. So now it works fine.

I have a cord going directly from the hub to the scout and the line from the scout to a punchblock that feeds the whole house on the second pair. The only bad thing is that I have to have the scout near the punch panel in the basement so that I can wire it right to that second pair (plugging right into the wall will default feed the first pair which I want dedicated to my primary phone.

So now that everything works like I want, I will get a line splitter (the kind that separates line one from line 2) so that I can plug the scout into the wall in the line 2 plug. Then I can put the hub and scout up where it's easier to check the v-mail.

For anyone who has the same problem ( I already got one email from another board member with the same issue) the ooma rep I spoke with who got he serial number changed on my account was named Tan Juna.

Who is online

Users browsing this forum: No registered users and 13 guests