Need extra help installing your Ooma Hub or Telo system? Let us know.
#11909 by southsound
Tue Jun 23, 2009 9:21 pm
#11925 by Aveamantium
Wed Jun 24, 2009 5:51 am
Scott

Any reason that you use ports instead of just using the SRC MAC or SRC IP (assuming you've setup a static IP for the hub) for the classification of the ooma? Just curious...
#11934 by StevenJohn
Wed Jun 24, 2009 6:37 am
That's what I done on my Tomato. I used the mac address instead of the ports. I also had to remove that bulk traffic line because it was overriding my ooma settings and making them low instead of highest. Just check the View Details page under QoS while on a call.

sj
#11935 by Aveamantium
Wed Jun 24, 2009 6:40 am
bmx,

I agree that ports don't change but I've just found it easier to assign a static IP to the router and then use the statically assigned Src IP for the classification, that way you can't miss since Tomato will shape all traffic from that IP address.

You need to put the ooma's Home Port IP (172.27.35.1) into the DMZ of the ooma hub. Then you should be able to access it using the IP that was assigned by Tomato (192.168.1.128 in your case).
Last edited by Aveamantium on Wed Jun 24, 2009 7:38 am, edited 2 times in total.
#11936 by Aveamantium
Wed Jun 24, 2009 6:46 am
Steven, you can avoid rules overriding each other by moving the ooma rule to the top (or any rule that you want to have precedence). Tomato process its rules from top to bottom and the first rule that is satisfied is how it is classified...
#11951 by Aveamantium
Wed Jun 24, 2009 9:30 am
Not unless you're doing P2P stuff... Not sure what else that port range covers?

Yeah, you're right though... Anything that gets through the rules should be classified as your default classification (or in you case Low).

Who is online

Users browsing this forum: No registered users and 10 guests