Need extra help installing your Ooma Hub or Telo system? Let us know.
#103714 by jh03
Fri Nov 30, 2012 12:36 pm
I only have mobile broadband and plug my USB modem into a Cradlepoint MBR900 router. Want to get the best voice quality from this setup. Since I cannot install Telo before the MBR900 router, is it possible to install Telo as the only device connected to the MBR900, then connect a wireless router (an older DLink) to the Home network port of the Telo? Is this possible, and has anybody done this? Any setup suggestions would be great. Thanks.
#103715 by lbmofo
Fri Nov 30, 2012 2:18 pm
I did a quick scan of your MBR900 and it doesn't seem like it can do QoS. If it did QoS, then you don't need to put the router after Ooma (so you won't need to get another router to put after Ooma).

In any case since you seem to really want QoS, the setup you are talking about is fine but just make sure you don't allow anything else to connect to MBR900 (can you disable wifi on MBR900?). In the setup you proposed, you want Ooma to be upstream to everything else that could connect to the internet (have the D-Link serve wifi and don't connect anything to the MBR900 other than Ooma, wifi and hardwired).

"Optimal Setup" posts for your reference

If after Router - viewtopic.php?t=12403

If before Router - viewtopic.php?t=9536#p66155
#104192 by jh03
Wed Dec 12, 2012 4:01 pm
Thank you, I reconnected Router 2.
However my Ooma connection is again breaking up badly (before changing the reconnection).
Before giving up on Ooma, should I do anything to Router1 (upstream of Telo) - such as:
- Placing telo in a DMZ?
- Something else, from your recommentations for telo behind router?
My upstream speed when measured with is 400k+.
However, when measured with phonepower or it drops one time during each test to under 200k - unacceptable. So, my verizon 3g connection may not be adequate.
#104193 by thunderbird
Wed Dec 12, 2012 4:19 pm
I connect the Ooma Telo Internet port, directly to one of my Cradlepoint MBR1200 LAN ports using network cables.

It works great using this connection, without setting up any Quality of Service settings in the Cradlepoint MBR1200.

In fact at times I connect up to four Ooma Telos to the the Cradlepoint MBR1200, using network cables and/or the Cradlepoint Wi-Fi signal, and they all work great.

If you have a fast enough Internet signal (enough bandwidth), then there is little concern for Quailiy of Service settings.

Is there 4G in your area?
Last edited by thunderbird on Wed Dec 12, 2012 5:13 pm, edited 2 times in total.

Who is online

Users browsing this forum: No registered users and 7 guests