Hub disassembly

Got something else to discuss that is not covered by the previous forums? Post it here!
Post Reply
sgreend
Posts: 3
Joined: Fri Jan 04, 2013 8:26 am

Hub disassembly

Post by sgreend » Fri Jan 04, 2013 8:53 am

Can someone tell me the trick to getting inside the original hub without destroying it? I have removed the four screws, including the three under the feet and the one under the label, but still can't crack the box open. I searched through the forum and found a topic on the scout disassembly (complete with pictures) but couldn't find anything similar on the hub. Thanks in advance for any help.

jonathan75
Posts: 17
Joined: Fri Jan 16, 2009 8:49 pm

Re: Hub disassembly

Post by jonathan75 » Sat Jan 05, 2013 6:24 pm

There are some plastic tabs in there. You have to use a thin plastic tool that is stiff to pop it up. If you use a metal tool you will make some marks and can damage the tabs. I can show you the tab locations with a picture but you would need to PM me for it. I don't think I can upload a picture to here. There are three tabs on each side evenly spaced and two on the top side where everything plugs in on at the outer edges outside of the plug locations.

Post Reply