Page 1 of 1

Ooma support for UPNP or NAT-PMP

Posted: Mon Oct 01, 2012 3:34 pm
by Raptor
I would like to use an Ooma setup that looks like this:

Router in Bridge Mode------>Ooma (Using PPPOE)-------->DSL Modem

This is preferred since my connection is quite limited in upstream bandwidth and I'd like to use Ooma's QOS. My only question is whether the Ooma Telo supports UPNP and/or NAT-PMP to allow devices to request open ports.

I don't see it explicitly in the setup anywhere.

Does anyone know for sure?

Thanks