2.18.x
|
|
| VAPI API Reference Documentation 2.18.x |
|
Defines | |
| #define | VAPI_DEV_OPMODE_DEFAULT 0 |
| #define | VAPI_DEV_OPMODE_RECOVER 0xff |
| #define | VAPI_DEV_PROF_DEFAULT 0 |
| #define | VAPI_DEV_PROF_SPU_FIRMWARE_DEFAULT 1 |
| #define | VAPI_DEV_PROF_SPU_DFECAN_ENABLE 2 |
| #define | VAPI_DEV_PROF_SPU_FSK_IP_DETECTION 3 |
| #define | VAPI_DEV_PROF_SPU_CUSTOM 4 |
| #define | VAPI_T38_OPMODE_NONE 0 |
| #define | VAPI_T38_OPMODE_TYPICAL 1 |
| #define | VAPI_T38_OPMODE_NETWORK 2 |
| #define | VAPI_T38_OPMODE_ENABLE 3 |
| #define VAPI_DEV_OPMODE_DEFAULT 0 |
send SPU CTRL + MULTICMD
| #define VAPI_DEV_OPMODE_RECOVER 0xff |
set Dev in ready state (Device UP, initialized, enable MULTICMD) and retrieve next variables by inquiring device: F/W MR, Eth MAC, Dev IP
| #define VAPI_DEV_PROF_DEFAULT 0 |
used by DeviceInit enable FSK
| #define VAPI_DEV_PROF_SPU_CUSTOM 4 |
used by DeviceInit enable according custom setting of pulUserParams
| #define VAPI_DEV_PROF_SPU_DFECAN_ENABLE 2 |
used by DeviceInit enable FSK + DFECAN
| #define VAPI_DEV_PROF_SPU_FIRMWARE_DEFAULT 1 |
used by DeviceInit does not enable any SPU features
| #define VAPI_DEV_PROF_SPU_FSK_IP_DETECTION 3 |
used by DeviceInit enable FSK + IP detect
| #define VAPI_T38_OPMODE_ENABLE 3 |
NETWORK + Enable the channel for UDPTL or RTP transmission
| #define VAPI_T38_OPMODE_NETWORK 2 |
TYPICAL + IP Parameters heritated from VoIP
| #define VAPI_T38_OPMODE_NONE 0 |
No command is sent to the FoIP channel after switch
| #define VAPI_T38_OPMODE_TYPICAL 1 |
FaxOPT and FaxLVL commands are sent to the FoIP channel